STM32:外部晶振时钟配置

void SystemClock_Config(void)

{

RCC_DeInit();

RCC_HSEConfig(RCC_HSE_ON); //INPUT HSE = 24M

ErrorStatus HSEStartUpStatus = RCC_WaitForHSEStartUp();

if(HSEStartUpStatus == SUCCESS) 

{

FLASH_PrefetchBufferCmd(ENABLE);    //M0 defined 

FLASH_SetLatency(FLASH_Latency_1);  //M0 defined 

RCC_PREDIV1Config(RCC_PREDIV1_Div1);

RCC_PLLConfig(RCC_PLLSource_PREDIV1, RCC_PLLMul_2);   //PLL CLK = HSE *RCC_PLLSource_PREDIV1*2 = 48M  

RCC_PLLCmd(ENABLE);                                   //enable PLL CLK

while(RCC_GetFlagStatus(RCC_FLAG_PLLRDY) == RESET)    //WAIT PLL CLK ready 

{

}

RCC_SYSCLKConfig(RCC_SYSCLKSource_PLLCLK); //SELECT SYSCLK = PLLCLK =48M

// *           - 0x00: HSI used as system clock

// *           - 0x04: HSE used as system clock  

// *           - 0x08: PLL used as system clock

// *           - 0x0C: HSI48 used as system clock, applicable only for STM32F072 devices  

while(RCC_GetSYSCLKSource()!=0x08)

{

}

RCC_HCLKConfig(RCC_SYSCLK_Div1); //AHB CLK(HCLK) = SYS CLK = 48M

RCC_PCLKConfig(RCC_HCLK_Div1);   //APB CLK(PCLK) = HCLK = 48M

RCC_USARTCLKConfig(RCC_USART1CLK_PCLK);  // UART2 CLK = 48M

RCC_USARTCLKConfig(RCC_USART2CLK_PCLK);  // UART2 CLK = 48M

RCC_I2CCLKConfig(RCC_I2C1CLK_SYSCLK);    // I2C CLK =48M

RCC_USBCLKConfig(RCC_USBCLK_PLLCLK);     // USB CLK = 48M

}

}