pic18 configuration settings---MCC编译器

//-----------------------------------------------

   // PIC18 MCC PIC18F6622 CONFIG BITS  1=OFF

   //CONFIG1H  禁止振荡器切换，禁止故障保护时钟，HS振荡器

   //CONFIG2L　欠压复位电压最大值，禁止欠压复位，禁止上电延时

   //CONFIG2H  关看门狗及喂狗时间　

   //CONFIG3H 使能MCLR，高功耗TIMER1，CCP2与RC1复用

   //CONFIG4L 后台调试关，扩展指令开,BOOT引导区2K，使能单电源,堆栈溢出复位 

   //CONFIG5L BLOCK0-3代码不保护

   //CONFIG5H EEPROM&引导区　代码不受保护

   //CONFIG6L BLOCK0-3 不受写保护

   //CONFIG6H  数据EEPROM　引导区　配置寄存器不保护

   //CONFIG7L 禁止其它块对BLOCK0-3执行表读操作

   //CONFIG7H 禁止其它块对引导区（000000-0007FFh）执行表读操作

   //-----------------------------------------------

   #pragma config  IESO  = OFF,  FCMEN   = OFF , OSC    = HS

   #pragma config  BORV  = 0  ,  BOREN   = OFF , PWRT   = OFF

   #pragma config  WDT   = OFF,  WDTPS   = 128

#pragma config  MCLRE = ON ,    LPT1OSC = ON  , CCP2MX = PORTC

#pragma config DEBUG = OFF,  BBSIZ   = BB2K, XINST  = ON ,  LVP   = ON , STVREN = ON 

#pragma config  CP0   = OFF,  CP1     = OFF , CP2    = OFF,  CP3   = OFF

#pragma config CPD   = OFF,  CPB     = OFF

#pragma config  WRT0  = OFF,  WRT1    = OFF , WRT2   = OFF,  WRT3  = OFF

#pragma config WRTD  = OFF,  WRTB    = OFF , WRTC   = OFF  

#pragma config  EBTR0 = ON ,  EBTR1   = ON  , EBTR2  = ON

#pragma config EBTRB = OFF